Third Generation F-Body Message Boards

DFI and ECM Discuss all aspects of DFI (Digital Fuel Injection), ECMs (Electronic Control Module), scanners, and diagnostic equipment. Fine tune your Third Gen computer system for top performance.

Problems withMoates software

Thread Tools
 
Search this Thread
 
Old Mar 17, 2003 | 07:59 PM
Share
  #1  
Ovrclck350's Avatar
Ovrclck350
Thread Starter
Supreme Member
 
Joined: Oct 2000
Posts: 2,572
Likes: 1
From: Longview, Tx
Problems withMoates software
My cable works fine with Datamaster 8d, but I can't get a connection with Moates software.....any suggestions?
Reply
0
Old Mar 19, 2003 | 08:31 AM
Share
  #2  
Grim Reaper's Avatar
Grim Reaper
TGO Supporter
 
Joined: Jul 1999
Posts: 10,907
Likes: 4
From: The Bone Yard
Car: Death Mobile
Engine: 666 c.i.
Have you posted this question on the DIY Prom Board? LOTS of guys have gotten Craig's software to work (though I use Diacom because I bought it YEARS ago).
Reply
0
Old Mar 20, 2003 | 01:14 AM
Share
  #3  
Ovrclck350's Avatar
Ovrclck350
Thread Starter
Supreme Member
 
Joined: Oct 2000
Posts: 2,572
Likes: 1
From: Longview, Tx
Maybe I should. I didn't know which one to post it on. It has to do with the ECM, but it also has to do with Prom Burning, sorta.
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
loss of power after 4000 RPM's
pjsparts
Tech / General Engine
11
Oct 29, 2025 06:39 PM
Manual swap problems
88rscamar0
Transmissions and Drivetrain
5
Sep 23, 2015 09:08 PM
Replaced starter and fusible links still wont crank.
383cam
Electronics
5
Sep 9, 2015 06:01 AM
88 gta digital dash problem?
andy74
Electronics
2
Sep 3, 2015 08:41 AM
Correct IAC part?
greenyone
TPI
3
Sep 2, 2015 03:39 PM
Back to Subforum
DFI and ECM
View Next Unread
Parting 87 Iroc




Advanced Search

All times are GMT -5. The time now is 05:36 AM.