Fan Control
#1
TGO Supporter
Thread Starter
Join Date: Oct 2003
Location: Houston / The Woodlands, TX
Posts: 302
Likes: 0
Received 0 Likes
on
0 Posts
Car: 82 ElCamino, looking for a 3rd gen
Engine: 305 TPI(427SB in progress) 730 $8D
Transmission: THM350 (Getting a 4L80E soon)
Axle/Gears: 10 Bolt w/ 2.43 gears :(
Fan Control
Is the 730 ECM capable of controlling 2 fans independently? If so what pin does the second relay need to be connected to? Also what pin does the A/C high side pressure(fan control not high pressure cut out)switch go on or should I wire that directly to the fan control relay.
#2
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,401
Likes: 0
Received 215 Likes
on
201 Posts
Car: check
Engine: check
Transmission: check
Re: Fan Control
Originally posted by eric305TPI
Is the 730 ECM capable of controlling 2 fans independently? If so what pin does the second relay need to be connected to? Also what pin does the A/C high side pressure(fan control not high pressure cut out)switch go on or should I wire that directly to the fan control relay.
Is the 730 ECM capable of controlling 2 fans independently? If so what pin does the second relay need to be connected to? Also what pin does the A/C high side pressure(fan control not high pressure cut out)switch go on or should I wire that directly to the fan control relay.
Pin E8 is the primary fan control (stock as used in F body's)
Pin F8 is the secondary fan control (not used in F body's, but in use in Y body's).
Pin D12 is the A/C status input for fan control (stock as used in F body's).
Pin C9 is an A/C compressor signal to the ECM. Not sure what the ECM uses it for, probably IAC idle control.
RBob.
Thread
Thread Starter
Forum
Replies
Last Post
formula1LE
Engine/Drivetrain/Suspension Parts for Sale
1
09-12-2015 08:31 PM