Flashing Computer
08-23-2004, 02:14 PM
#1
Banned
Thread Starter
iTrader: (1)
Join Date: May 2003
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
Flashing Computer
I have a 1991 Camaro Z28 with a L98 350 motor and was wondering if I have to flash the computer to change the chip from a Auto to Manual once I do the T56 swap next spring. If anybody could explain to me in full (I am anewbie to the world of ECM's) what has to be done I would appreciate this. Sorry if you have seen a post similar to this by me in another section. 
08-23-2004, 03:33 PM
#2
Supreme Member
Join Date: Jun 2000
Location: In reality
Posts: 7,554
Likes: 0
Received 1 Like
on
1 Post
Car: An Ol Buick
Engine: Vsick
Transmission: Janis Tranny Yank Converter
Re: Flashing Computer
Originally posted by STOLN
I have a 1991 Camaro Z28 with a L98 350 motor and was wondering if I have to flash the computer to change the chip from a Auto to Manual once I do the T56 swap next spring. If anybody could explain to me in full (I am anewbie to the world of ECM's) what has to be done I would appreciate this. Sorry if you have seen a post similar to this by me in another section.
I have a 1991 Camaro Z28 with a L98 350 motor and was wondering if I have to flash the computer to change the chip from a Auto to Manual once I do the T56 swap next spring. If anybody could explain to me in full (I am anewbie to the world of ECM's) what has to be done I would appreciate this. Sorry if you have seen a post similar to this by me in another section.
Drop down to the DIY PROM Board and start reading the stickies.
If everything is stock, and you're happy with the stock type programming, then just swapping out the *chip* will be all you need to do.
Thread
Thread Starter
Forum
Replies
Last Post
Damon
Tech / General Engine
8
09-26-2015 04:29 PM
