DFI and ECM Discuss all aspects of DFI (Digital Fuel Injection), ECMs (Electronic Control Module), scanners, and diagnostic equipment. Fine tune your Third Gen computer system for top performance.

Not running

Thread Tools
 
Search this Thread
 
Old Jun 24, 2007 | 09:24 PM
  #1  
bobbysnapps's Avatar
Thread Starter
Junior Member
 
Joined: Jan 2007
Posts: 16
Likes: 0
From: Michigan
Car: 86 iroc z
Engine: 305 tpi
Transmission: 700r4
Axle/Gears: 3.42:1
Not running

my 86 iroc is not running

it was stalling about two months ago every once awhile and my gages were blowing fuses, but the fuses are staying in now, and ever since i owned the car my rpm gage will peg out when the motor is off and and when restarted it will stay there until the rpms go up to about 3 to 3.5, now my car is not running at all i drove it to a friend's house and it never restarted acted like a fuel pump, but since the computer controls it is it possible that the computer fryed out, and if so where can i find a new one at a reasonable price?

checked fuel pump by pulling line off feed and rolling engine over and no gas was coming out
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
2
Dec 16, 2024 01:50 PM
Azrael91966669
DIY PROM
25
Jun 20, 2017 04:04 AM
Fast355
DFI and ECM
14
Dec 2, 2016 06:33 PM
perZ
TPI
3
Aug 21, 2015 05:51 PM
ezobens
DIY PROM
8
Aug 19, 2015 10:29 PM




All times are GMT -5. The time now is 11:58 AM.