Ebl p4 flash tuning kit
Thread Starter
Senior Member
Joined: May 2011
Posts: 855
Likes: 1
From: New Bedford MA
Car: 1988 Gta trans am
Engine: LR4 4.8
Transmission: 98-02 t56 6 speed
Axle/Gears: Bw 9 bolt (3.70’s) pbr rotors
Ebl p4 flash tuning kit
Ok so im switching over from maf to sd and also got the ebl flash p4 tuning kit im having a problem i dont have power going to the map sensor i do how ever have power coming out of pin c on the tps sensor which goes from the tps to map sensor what did i do wrong im wondering if i messed up repinning the connectors and put one in the wrong spot
Moderator
iTrader: (1)
Joined: Mar 2002
Posts: 18,432
Likes: 233
From: Chasing Electrons
Car: check
Engine: check
Transmission: check
Re: Ebl p4 flash tuning kit
It's possible that something was re-pinned incorrectly. Also, as the MAP sensor needs to be added in (wired & plumbed), it is possible that the connector for it was wired incorrectly.
Just take your time and double check these items. If you didn't get the re-pin guide let me know and I'll send it.
Also, be sure to use the WUD Diagnostic display to review the sensor values. They will be the raw, direct from the sensor, values.
RBob.
Just take your time and double check these items. If you didn't get the re-pin guide let me know and I'll send it.
Also, be sure to use the WUD Diagnostic display to review the sensor values. They will be the raw, direct from the sensor, values.
RBob.
Thread
Thread Starter
Forum
Replies
Last Post