DFI and ECM Discuss all aspects of DFI (Digital Fuel Injection), ECMs (Electronic Control Module), scanners, and diagnostic equipment. Fine tune your Third Gen computer system for top performance.

Tested 1227165 ECM w/ my memcal,chip ANY 8990 install

Thread Tools
 
Search this Thread
 
Old 03-14-2019, 12:10 AM
  #1  
Junior Member
Thread Starter
 
Mallep1's Avatar
 
Join Date: Jan 2019
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
Tested 1227165 ECM w/ my memcal,chip ANY 8990 install

Need help I'm at a lost
86 IROC Z28 with the 305 v8 with automatic transmission new battery
started right up after setting all winter idle at 1200 sounded good check engine light did not give me the code * ** it faded in and out then stayed on I tried to kick the idle down but it went to 1500rpm temp was 160 deg so I turned it off now for some reason when I turn the key its click click click from the starter solenoid any help with this would be greatly appreciated my first thought was a short fuseable link but I dont no anything about ECM

86 iroc w/305 v8 auto trans. all original stock

Last edited by Mallep1; 03-14-2019 at 10:05 AM. Reason: Add more info
Old 03-14-2019, 12:11 PM
  #2  
Sponsor

iTrader: (92)
 
Tuned Performance's Avatar
 
Join Date: Dec 2004
Location: Mile High Country !!!
Posts: 15,449
Received 666 Likes on 590 Posts
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: Tested 1227165 ECM w/ my memcal,chip ANY 8990 install

If the starter just clicked and the car sat all winter without being started. I would check the battery or have it load tested after you charge it.
Old 03-15-2019, 07:47 AM
  #3  
Junior Member
Thread Starter
 
Mallep1's Avatar
 
Join Date: Jan 2019
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
Re: Tested 1227165 ECM w/ my memcal,chip ANY 8990 install

I bought a new battery to make sure it had a full charged I will check the starter out

thank u
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
BigLou907
Body
12
05-26-2012 06:06 PM
speedmachine
DFI and ECM
3
08-14-2007 07:28 AM
Sleeper_Z
Exterior Parts for Sale
6
05-24-2007 04:49 PM



Quick Reply: Tested 1227165 ECM w/ my memcal,chip ANY 8990 install



All times are GMT -5. The time now is 05:18 PM.