TCC Lock up help.

Reply Subscribe

Thread Tools

Search this Thread

Jul 19, 2002 | 10:35 AM

87_TA

Thread Starter

TGO Supporter

Joined: Dec 2001

Posts: 2,308

Likes: 0

From: ELIZABETH,PA,USA

TCC Lock up help.

Sorry i know this does not exactly belong on this board but there are many here w/experience in this dept.

I just installed new converter 3000 holeshot B&M Lock up,
My previous converter lockup worked just fine ,this one is not locking at all - i have spoken to the tech line and they suggest checking the lock up solenoid by putting 12v to it and listening for the click.
My question is can i put 12v to the TCC solenoid pin GF6 on the connector off the ecm to check it?

Thanks for any help.

Jul 19, 2002 | 01:14 PM

Grumpy

Supreme Member

Joined: Jun 2000

Posts: 7,554

Likes: 1

From: In reality

Car: An Ol Buick

Engine: Vsick

Transmission: Janis Tranny Yank Converter

Re: TCC Lock up help.

Quote:

Originally posted by 87_TA
Sorry i know this does not exactly belong on this board but there are many here w/experience in this dept.

I just installed new converter 3000 holeshot B&M Lock up,
My previous converter lockup worked just fine ,this one is not locking at all - i have spoken to the tech line and they suggest checking the lock up solenoid by putting 12v to it and listening for the click.
My question is can i put 12v to the TCC solenoid pin GF6 on the connector off the ecm to check it?

Thanks for any help.

The ecm supplies the GROUND for the TCC solenoid to apply..