wideband o2 sensor calibration info?
Thread Starter
TGO Supporter
Joined: Aug 2001
Posts: 1,008
Likes: 0
From: NJ/PA
Car: Yes
Engine: Many
Transmission: Quite a few
wideband o2 sensor calibration info?
Guys,
I'm looking into building one(got the sensor, working on the component bom). I've looked at the wb website, especially in the testing section. I'm just a little unclear about one thing, the calibration resistor. Does this need to be added to the unit to set the stoich point voltage? It seems to be just a test to verify that the current pump is working, there's really not a whole lot mentioned about it, but it says something about being in the sensor harness? can anyone shed some light?? many thanks. Joe
I'm looking into building one(got the sensor, working on the component bom). I've looked at the wb website, especially in the testing section. I'm just a little unclear about one thing, the calibration resistor. Does this need to be added to the unit to set the stoich point voltage? It seems to be just a test to verify that the current pump is working, there's really not a whole lot mentioned about it, but it says something about being in the sensor harness? can anyone shed some light?? many thanks. Joe
Supreme Member
Joined: Jun 2000
Posts: 7,554
Likes: 1
From: In reality
Car: An Ol Buick
Engine: Vsick
Transmission: Janis Tranny Yank Converter
Re: wideband o2 sensor calibration info?
Originally posted by jwscab
Guys,
I'm looking into building one(got the sensor, working on the component bom). I've looked at the wb website, especially in the testing section. I'm just a little unclear about one thing, the calibration resistor. Does this need to be added to the unit to set the stoich point voltage? It seems to be just a test to verify that the current pump is working, there's really not a whole lot mentioned about it, but it says something about being in the sensor harness? can anyone shed some light?? many thanks. Joe
Guys,
I'm looking into building one(got the sensor, working on the component bom). I've looked at the wb website, especially in the testing section. I'm just a little unclear about one thing, the calibration resistor. Does this need to be added to the unit to set the stoich point voltage? It seems to be just a test to verify that the current pump is working, there's really not a whole lot mentioned about it, but it says something about being in the sensor harness? can anyone shed some light?? many thanks. Joe
Thread
Thread Starter
Forum
Replies
Last Post
efiguy
Engine/Drivetrain/Suspension Parts for Sale
0
Sep 27, 2015 01:30 PM
