Target IAC steps = 0..always?
Thread Starter
Senior Member
Joined: Sep 2001
Posts: 864
Likes: 0
From: Santa Maria Ca
Target IAC steps = 0..always?
I finally got my scanner hooked up a day or two ago and dont know what to make of some of this stuff.
right now im trying to get the idle down first
The target IAC steps is always 0.....does this mean I have a vaccum leak? The present steps are all over the place , but go between 17 and 26.
I have reset the IAC and the TPS according to the tech article.
right now im trying to get the idle down first
The target IAC steps is always 0.....does this mean I have a vaccum leak? The present steps are all over the place , but go between 17 and 26.
I have reset the IAC and the TPS according to the tech article.
TGO Supporter
Joined: Dec 2001
Posts: 2,308
Likes: 0
From: ELIZABETH,PA,USA
The target IAC steps is always 0.....does this mean I have a vaccum leak? The present steps are all over the place , but go between 17 and 26.
At idle what are you showing in gear? between 17 - 26?
But you are showing (0) as target? I don't remember there being a target iac steps.
Just trying to understand more of what you are experiencing.
Does car idle and drive part throttle ok?
Thread
Thread Starter
Forum
Replies
Last Post
Gunner242
Electronics
7
Dec 25, 2015 04:49 PM
