I am using tunerpro rt w/ prominator in my car and been trying to get the BLM's in order. I changed the scalar tables and I get close but the BLM/INT are moving around. I try to change the maf table but it wont save the values I put in. I tried 3 computers and no differance. When I save it, it tell me there is a new checksum but when I bring up the table there is no change in values. I am using $6e arap and contiplating if I should go to $32. Anybody run into this? Another question is should I tune w/EGR on or off? The car runs richer with it on.

 

if you set a maf table value to high it will not save

 

whats to high?

I added 1% and still did not save