Looking for Open Loop at Idle Only!HELP
Thread Starter
Junior Member
Joined: Sep 2004
Posts: 78
Likes: 0
From: Riverside, CA
Car: 64 Studebaker Avanti,67 ElCaminoTBI
Engine: GM 350 10.5:1 Supercharged
Transmission: 700R4
Axle/Gears: 3.54 posi
Looking for Open Loop at Idle Only!HELP
Do to the cam I'm running I'm looking for a way to make the computer go into open loop at <1000 RPM.
92 Camero computer 1227730 PROM AUJP with Tunercat.
Please Help!
92 Camero computer 1227730 PROM AUJP with Tunercat.
Please Help!
Moderator
iTrader: (1)
Joined: Mar 2002
Posts: 18,432
Likes: 233
From: Chasing Electrons
Car: check
Engine: check
Transmission: check
Re: Looking for Open Loop at Idle Only!HELP
Originally posted by AvantiHall
Do to the cam I'm running I'm looking for a way to make the computer go into open loop at <1000 RPM.
92 Camero computer 1227730 PROM AUJP with Tunercat.
Please Help!
Do to the cam I'm running I'm looking for a way to make the computer go into open loop at <1000 RPM.
92 Camero computer 1227730 PROM AUJP with Tunercat.
Please Help!
As for open loop idle I don't believe there is any functionality built into the $8D mask to do this. The easiest method would be to add an RPM qualifier next to the temperature qualifier to allow closed loop. An easy code change.
Where it checks the termperature qualifier, add in another that checks the RPM. If RPM >= 1,000, then closed loop is OK.
RBob.
Thread
Thread Starter
Forum
Replies
Last Post
