I'm having some issues with my conversion and I'm not sure if the BIN I have is clean. Anyone knows where I can get a clean $5D BIN for a 350 TPI? I'm using Tunercat. TIA

 

I have some 5D/808 bins from Ben73. I have not tried them, but I will share them with you. Is there one in particular that you want? I will be home tomorrow, and cand send them out if you send me your email. BTW- where in Florida are you?

 

I'm in Lake Worth in Palm Beach county. You can email them to torres_a@hotmail.com. Wold be nice if I can get one that has been run on a 350. Thanks

 

I saw a link somewhere in this forum some time ago that showed what bin goes to what, you might search for it. I have them listed in a file, but I dont know which are for 350's and which arent. These are all stock AFAIK, maybe ben73 will chime in and spread some knowledge. Too bad your not closer to Lakeland, It would be nice to have someone local to tune with. I will email them to you tomorrow.

 

Try this site here

Adrian

 

HD4mula, I checked the link provided by Adrian, and didnt see any bins that were $5d/808 for a 5.7. Perhaps this wasnt an option. Irregardless, I will send you what I have.

 

Thanks all Finally got the engine running. My problem was a bad Calpak. I had two good ECMs with both Calpaks defective Anyway got a good one from a running car and engine started easily. Anyone knows where I can buy a new calpak for a 165 ECM? Thanks