Was wondering if anyone has any pics of thier tailpipe adapter for a wideband O2?

I finally ordered one, and because of the season, I think I will not have time to get the bung welded in until after the first of the year. I can however build an adapter, just to play with the unit when it gets here. Will of course add the bung to the exhaust ASAP, but until then....

Any rough measurements of total length, etc, would also be appreciated.

Thanks!!

 

1.5" diameter, 9" long piece of tailpipe.
6" down welded a bung in.
Then a pair of needle nosed vise grips 90d from the bung.

The 6" part goes into the tail pipe.

If you can go longer, then make it a foot long.

Just remember that being back that far adds some lag to what's reported compared to what's commanded.

 

Thanks. Like i said this is not permanent, but will use it from time to time.