Trying to datalog...
Thread Starter
Senior Member
Joined: Oct 2003
Posts: 942
Likes: 0
From: LaGrange (10min from Poughkeepsie), NY
Car: 1992 Camaro RS - not real slow anymore...
Engine: SPDC 360 MAF EFI /w a Holley Stealth Ram
Transmission: T5 untill it blows up from to much torque
Axle/Gears: Ford 9" /w auburn pro & 3.89's
Trying to datalog...
I got the ALDU1 converter and the CABL1 OBD1 connector. I hooked everything up and cannot connect to the "hardware." I selected Com port 3 and tunerpro RT verified it. I then try and connect and it fails. And when I goto check the com port again, it say's, "not found." But, as soon as I restart the program again, its magically found once more! -Still won't connect though. Anyone know whats up?
PS: SES light blinks when connected.
PS: SES light blinks when connected.
Senior Member
Joined: Jul 1999
Posts: 853
Likes: 0
From: Everett, MA . USA
Car: 89 FORMULA FIREBIRD, 86 CHEVY CAMARO
Engine: L98, LB9 RESPECTIVLY
Transmission: 700 R4 (BOTH)
You got the switch on your aldu1 in the grounded position, this puts your ecm in diag mode. Try it with the switch in the center or
up position. The switch should be on the right side of the cable.
up position. The switch should be on the right side of the cable.
Joined: May 2004
Posts: 2,262
Likes: 1
From: houston
Car: 83 POS monte carlo 2015 chevy P/U
Engine: 92 5.7 tpi 5.3
Transmission: 700r4 6L60E
Axle/Gears: 2.42 too high
also check in the "Tools" tab go to "Preferences", then go to ALDL/Emulation & see what the interface type is set to, i think you should be set to MAX232.
Thread
Thread Starter
Forum
Replies
Last Post