where to get started
#1
Member
Thread Starter
Join Date: Apr 2001
Location: Edmond, OK, USA
Posts: 427
Likes: 0
Received 1 Like
on
1 Post
Car: 87 IROC
Engine: 305 TPI going to LT1
Transmission: 5spd
where to get started
where can i get prom burning equipment? what do i need? i would like to get started in it but have no idea where to begin. thanks for the help
Andrew
------------------
Andrew Peery
1987 IROC, 305 TPI, T5
Hooker Competition Ceramic Coated Headers, Flowmaster, Ported Plenum
All smog equipment gone and no cat
before headers
192hp and 265tq
15.20 @ 92.5 mph 2.4 60ft
After Headers
14.480 @ 95.01mph 2.194 60ft
Andrew
------------------
Andrew Peery
1987 IROC, 305 TPI, T5
Hooker Competition Ceramic Coated Headers, Flowmaster, Ported Plenum
All smog equipment gone and no cat
before headers
192hp and 265tq
15.20 @ 92.5 mph 2.4 60ft
After Headers
14.480 @ 95.01mph 2.194 60ft
#3
Member
Thread Starter
Join Date: Apr 2001
Location: Edmond, OK, USA
Posts: 427
Likes: 0
Received 1 Like
on
1 Post
Car: 87 IROC
Engine: 305 TPI going to LT1
Transmission: 5spd
thank you master of the obvious
but what i meant to put and did put on my other post is can i get used stuff cheaper and if so where?
i tried to delete this post but it wouldn't allow me so oh well.
thanks though
Andrew
but what i meant to put and did put on my other post is can i get used stuff cheaper and if so where?
i tried to delete this post but it wouldn't allow me so oh well.
thanks though
Andrew
#5
Member
Join Date: Apr 2000
Location: The Great White North
Posts: 243
Likes: 0
Received 0 Likes
on
0 Posts
Just watch the classifieds section. A while ago there was a pocket programmer for sale on there, but it's doubtful that your going to find this stuff used cause anyone who has it keeps it. It doesn't cost that much anyway, if you use a flash eprom you can forget the eraser, although it is still handy to have.
Thread
Thread Starter
Forum
Replies
Last Post
92camaroJoe
Tech / General Engine
6
08-13-2015 06:07 AM