Power enrichment vs. RPM
Thread Starter
Member
Joined: Aug 2001
Posts: 294
Likes: 2
From: SoCal
Car: '85 Trans Am FAILBIRD
Engine: 350
Transmission: T56
Axle/Gears: 4th gen torsen 3.42
Power enrichment vs. RPM
Am I correct in assuming that this is only under load? I was expecting a 3d table for enrichment vs. tps vs. rpm.
My issue is that I have a 355 w/ a 228/236 cam and headers under a '89 TPI. I can't run the car with the MAF connected, it's WAY too lean. not sure what to do... for the time being it's running w/o the MAF and with the engine light always on
My issue is that I have a 355 w/ a 228/236 cam and headers under a '89 TPI. I can't run the car with the MAF connected, it's WAY too lean. not sure what to do... for the time being it's running w/o the MAF and with the engine light always on
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
Sep 17, 2020 08:26 AM
sailtexas186548
Problems / Help / Suggestions / Comments
2
Aug 24, 2015 10:11 PM
mdtoren
Tech / General Engine
0
Aug 16, 2015 05:45 PM
