I'm running a RamJet 350 with a 730 ECM. I haven't been able to get the idle to work properly. Runs quite well everywhere else, and the BLMs are fairly good above idle also. Anyway, I'm going to start over since I have a pretty good bin for everywhere buy idle.
I need a little guidance on the initial mechanical settings since the RamJet values are a little goofy as shown below:

TP Sensor 0.70-0.80 volts with Idle Air Control at 20-40 counts.

The 20-40 counts sounds ok, but that TPS voltage seems a bit high. What would be a sat value to TPS voltage?

I'm going to set the timing to 6 degrees (per the AXCN Bin) and start there.