can't find DE table in $D8?

Subscribe
Jun 16, 2008 | 04:35 PM
  #1  
i'm using $d8 for the first time last night and could not find a table for de anywhere in the lists in tunerpro.


doing some searching today i can't seem to find a good answer. so i guess i'll just use up some bandwith and ask.


does it have one? and if so, whats it called? i have a big rich spike yeah you left of the gas and need to up the de some.

thanks.
Reply 0
Jun 16, 2008 | 07:57 PM
  #2  
Re: can't find DE table in $D8?
DE = Deceleration enrichment????

I'm guessing by your description.... but there is something in there along those lines

-jason
Reply 0
Jun 16, 2008 | 08:05 PM
  #3  
Re: can't find DE table in $D8?
Quote: DE = Deceleration enrichment????

I'm guessing by your description.... but there is something in there along those lines

-jason
yeah.. my bad. its just called de in code 59 I believe.
Reply 0
Jun 16, 2008 | 09:50 PM
  #4  
Re: can't find DE table in $D8?
There is both deceleration enleanment (DE) and deceleration fuel cut off (DFCO) in the 8D. I think they start at about address #85A6 if you can edit the binary. Otherwise you need an XDF like SAUJP V4 for Tunerpro. Should be available on Moates site.
Reply 0
Jun 17, 2008 | 02:26 PM
  #5  
Re: can't find DE table in $D8?
Quote: There is both deceleration enleanment (DE) and deceleration fuel cut off (DFCO) in the 8D. I think they start at about address #85A6 if you can edit the binary. Otherwise you need an XDF like SAUJP V4 for Tunerpro. Should be available on Moates site.


ahhh so its just not in the xdf that im using... that makes sense.



but yeah, i'm a long way away from being able to use the adress number to change stuff. i'm hoping to get that deep someday thou. i'm only a few months into this diy prom tuning as of now.


as for the saujp v4. i have it saved on my computer but wanted to start out with cleaning up the stock bin first to get my feet wet, that and since its a stick car, i hope to be able to compair the iac stuff to the saujp since i believe its an auto bin. just for the drivablty stuff.

but can i use the xdf from the saujp to edit my stock bin? i was thinking they were linked.
Reply 0
Subscribe