Where to start
Thread Starter
Junior Member
Joined: Aug 2008
Posts: 20
Likes: 0
Where to start
I have just gotten into the whole chip burning scene and it is difficult to figure out what a newbie has to do to get everything to turn out right. Can any one help me out with tuning my ecm?
I have a 16144288 ecm and I don't know how to get or make a definition file for this computer. It seems that every program needs a definition file i.e. .xdf or .tdi, is there any way around this or how hard would it be to make one myself? I would rather not buy one if I can avoid this. can this computer run any other code masks other then $A0?
Thanks
I have a 16144288 ecm and I don't know how to get or make a definition file for this computer. It seems that every program needs a definition file i.e. .xdf or .tdi, is there any way around this or how hard would it be to make one myself? I would rather not buy one if I can avoid this. can this computer run any other code masks other then $A0?
Thanks
Junior Member
Joined: Feb 2003
Posts: 95
Likes: 0
From: Texas
Car: 69 Camaro
Engine: 355 SBC
Transmission: Glide
Axle/Gears: 4.88 full spool
Re: Where to start
Here is a link to an .xdf for tunerpro and the $A0 mask
http://www.moates.net/files/3)%20Bin...0Motors/A0.xdf
----------
Here is a link to a hack for $A0
http://www.moates.net/files/5)%20Sou...20Hacks/A0.zip
http://www.moates.net/files/3)%20Bin...0Motors/A0.xdf
----------
Here is a link to a hack for $A0
http://www.moates.net/files/5)%20Sou...20Hacks/A0.zip
Last edited by 18436572; Sep 15, 2008 at 04:32 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM