Hello. I want to do a datalog with my 88´Pontiac Firebird TransAm TBI. My ECM is the 1228063. I have winaldl and an aldl-cable. Now, i´ve seen, there is no 1228063 in the winaldl-program...

What can I do ? Or should I use another programm ? Which programs are good for my 1228063-ECM ?

Thank you...

 

Use the data stream for the '8746.

RBob.

 

Do you mean the 1228746 ?

 

Yes. 1228746. That one should work fine for you. Are you able to burn your own chips? If not I recommend you contact Brian Harris at Harris Performance. www.tbichips.com or www.tpichips.com.

His phone number is 1-336-471-2827

Good luck!

What I have done in the past is email Brian my data and he modifies the bin and then i burn it. I have Moates' products to burn my own chips. Moates modified my 1228746 so i can easily remove my chip and put it in the flash/burn.

 

RBob...

I have been looking at www.DynamicEFI.com for some time now. I was going to change my 1228746 to 16136965. Brian states that it's basically the same, but able to set a few parameters wider with the 16136965.

What would i need from DynamicEFI.com so I dont have to remove my chips to burn them?

 

I bought a chip from Brian. It works very fine.
After the saison, i want to swap my camshaft to a LT1-Cam. I know, i need another chip. Now, i want to learn to do my own chips.
It´s very interesting for me.

 

Awesome! I hope things work well for you. I think I am going to convert my setup to DynamicEFI's.

 

If you are decent with soldering the self-install EBL is all that you need. There is an install guide on the site if you want to see what that entails. The only other required items is TunerPro and a laptop with a serial port. If no serial port then a USB-to-serial adapter cable works.

Note that any of the seventeen ECMs listed will work. Once the EBL Flash board is installed they are all the same. The XDF, doc's, software, serial cable, everything else comes with the package.

RBob.