Bin Stacking issues
Thread Starter
Junior Member
Joined: Jul 2009
Posts: 4
Likes: 0
From: Melbourne Australia
Car: 1934 Ford Sedan 4" Chop
Engine: 350 TPI
Axle/Gears: Jag IRS
Bin Stacking issues
Hope someone may be able to clear this up for me
When I stack my bin with TunerPro RT using 16k 512k and 64k all says it's stacked successfully but when I load file to buffer in Autoprom the editor reads all 0's. I tried stacking using different settings 16 64 16 and I can read the code. I am burning to 29F040 chip. I'm new to this but have got a handle on most things. Any help would be greatly appreciated
When I stack my bin with TunerPro RT using 16k 512k and 64k all says it's stacked successfully but when I load file to buffer in Autoprom the editor reads all 0's. I tried stacking using different settings 16 64 16 and I can read the code. I am burning to 29F040 chip. I'm new to this but have got a handle on most things. Any help would be greatly appreciated
Joined: May 2004
Posts: 2,262
Likes: 1
From: houston
Car: 83 POS monte carlo 2015 chevy P/U
Engine: 92 5.7 tpi 5.3
Transmission: 700r4 6L60E
Axle/Gears: 2.42 too high
Re: Bin Stacking issues
it seems i read somewhere when stacking and using the 29F040 chip with a 16k bin you need to use the 32k block size.
i don't remember if i read that here, at Moates, or at the TunerPro site.
i don't remember if i read that here, at Moates, or at the TunerPro site.
Thread
Thread Starter
Forum
Replies
Last Post
UltRoadWarrior9
Transmissions and Drivetrain
3
Sep 2, 2015 08:24 PM
