Reading chip with Burn 1 question
Thread Starter
Joined: Oct 1999
Posts: 549
Likes: 0
From: Apple Valley, MN
Car: 92 Z28 convertible
Engine: Miniram 383
Transmission: T-56
Axle/Gears: 4.10 stk 10 bolt
Reading chip with Burn 1 question
Im having a weird issue with my burn 1 for some reason. I had to wipe out my laptop recently and just re-loaded Tunerpro RT and my Burn 1 software. Well now I went and got my chip (29C256) and when I read it and save it, it only saves 1 bite of info??? So Tunerpro wont open the bin file? I downloaded the drivers from Moates site, but for some reason I can't read my chip and save it to see it?? Thanks in advance.
Thread Starter
Joined: Oct 1999
Posts: 549
Likes: 0
From: Apple Valley, MN
Car: 92 Z28 convertible
Engine: Miniram 383
Transmission: T-56
Axle/Gears: 4.10 stk 10 bolt
Re: Reading chip with Burn 1 question
After some further reserch, I found out that my chip end address was wrong. It had 000000 in there when it should have been 007FFF. Just a FYI for future searches.
Thread
Thread Starter
Forum
Replies
Last Post
