I've seen references to an expanded Inector constant vs. IAT table (factory table starts at 03A6) for the 8746, anyone know where I can find this?

Also, with the IAT table I'm assuming that number greater than '1' increases fuel at a given temperature and vice versa - correct?

Thanks!

 

I would also like this info - Anyone?

 

I've done a lot of searching and can't find it although the XDF fro JPrevost is available with extended temp range for IAT. But a warning that without the patch it will look uneven, and a stock bin looks uneven...

Although I don't need the patch it could be useful to others?

I'd like to incorporate them into IAT on a P4 16197427 that can enable MAT, but MAT numbers would be from CPI engine way off from IAT. The only starting point I can find for IAT would be from a MPFI like my LT1 but intake manifold temps on MPFI dry manifold would be quite different then TBI wet manifold.

So the extended numbers from $61 being IAT and TBI would be a great starting point!

Does anyone have this patch done and table from XDF with results?