ALDL Cable not working
Thread Starter
Joined: Jun 2003
Posts: 499
Likes: 12
From: Oak Harbor, WA
Car: 1990 IROC-Z
Engine: 383 HSR
Transmission: 700R4
Axle/Gears: 3.70
ALDL Cable not working
Just tried to connect to the car for the first time in ohhh...5 years and TPRT will not recognize my ALDL cable. Com port on laptop is set to 0001, hub 0001. Device manager recognizes it and the driver is installed, but TunerPro reports cable not found or functioning. Is there a way to test it, or is it a loss and I need a new cable?
TPRT recognizes the Ostrich 2.0, but not the ALDL cable.
ECM: 1227730 ECM
MASK ID: 8D
BIN: AUJP / 10APR2013.bin
XDF: 8D_WB_V5.XDF
ADX: 1227730_corrected.adx
Emulator: Ostrich 2.0
ALDL: OBD1 Cable with 3position switch
Software: TunerPro RT
TPRT recognizes the Ostrich 2.0, but not the ALDL cable.
ECM: 1227730 ECM
MASK ID: 8D
BIN: AUJP / 10APR2013.bin
XDF: 8D_WB_V5.XDF
ADX: 1227730_corrected.adx
Emulator: Ostrich 2.0
ALDL: OBD1 Cable with 3position switch
Software: TunerPro RT
Thread Starter
Joined: Jun 2003
Posts: 499
Likes: 12
From: Oak Harbor, WA
Car: 1990 IROC-Z
Engine: 383 HSR
Transmission: 700R4
Axle/Gears: 3.70
Re: ALDL Cable not working
Ok, I guess that may have been a stupid question...LOL I just ordered a new cable from Craig. Stay well fellas.
Joined: Dec 2004
Posts: 16,751
Likes: 995
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: ALDL Cable not working
Did you try all your com ports. I had the same thing happen recently with a 730. The previous com port I had tp set to didn’t work.
Thread Starter
Joined: Jun 2003
Posts: 499
Likes: 12
From: Oak Harbor, WA
Car: 1990 IROC-Z
Engine: 383 HSR
Transmission: 700R4
Axle/Gears: 3.70
Re: ALDL Cable not working
Well thanks for that tip! It works on COM port 3! I guess I'm going to have a spare here shortly.
Thread
Thread Starter
Forum
Replies
Last Post
danielr1211
DIY PROM
17
Sep 20, 2013 01:13 PM