Where do you set max spark in the 7747?
Thread Starter
Supreme Member
iTrader: (1)
Joined: Jun 2001
Posts: 1,520
Likes: 0
From: 600 yds out
Car: Bee-Bowdy
Engine: blowd tree-fity
Transmission: sebin hunnerd
Axle/Gears: fo-tins
Where do you set max spark in the 7747?
I was reading the archives and saw that you want your peak SA to occur around your peak torque, but all posts were for 730 ECM's.
Senior Member
Joined: Oct 1999
Posts: 6,621
Likes: 2
Car: 91 Red Sled
Axle/Gears: 10bolt Richmond 3.73 Torsen
Not sure about that when using TBI and the 8746 ecm. TPI (7730) has a different torque curve when swapped onto most engines so I don't think it's something you could just say is true for TBI.
Try it out. I noticed that if I have too much advance too early and get good traction the car hates me. Also the peak torque is usually not a specific rpm. You'll notice that it's flat so the max timing could be a span of 1000rpm or more depending on how accurate you think you know "where" your max torque is.
Try it out. I noticed that if I have too much advance too early and get good traction the car hates me. Also the peak torque is usually not a specific rpm. You'll notice that it's flat so the max timing could be a span of 1000rpm or more depending on how accurate you think you know "where" your max torque is.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
evilstuie
Exhaust
24
Feb 28, 2016 03:33 PM