Turn signal lever replacement.
Thread Starter
Member
Joined: Nov 2000
Posts: 219
Likes: 0
From: FL
Turn signal lever replacement.
The washer tab on my combination turn/cruise/wiper snapped. I bought a new one today. What is the easiest way to replace this? Do I have to tear apart the steering column?
------------------
89 RS V-8
------------------
89 RS V-8
Supreme Member
Joined: Jul 1999
Posts: 1,335
Likes: 2
From: Tucson, AZ, USA
Car: '92 Z28; Dk Teal; Her Pkg
Engine: 305
Transmission: Richmond 6 Spd
Axle/Gears: Moser 9", Detroit Locker, 3.70
Remove the tilt lever (it unscrews), make sure the multifunction lever is in the center or "off" position, remove the housing cover end cap (if you have cruise control), remove the cruise control connector (if you have cruise control), remove the multifunction lever by pulling it straight out of the turn signal switch.
Tim
Tim
Thread
Thread Starter
Forum
Replies
Last Post