Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

Oil Pressure gauge messed up

Thread Tools
 
Search this Thread
 
Old Aug 1, 2002 | 03:22 PM
  #1  
DuffMan's Avatar
Thread Starter
Member
iTrader: (1)
 
Joined: Jul 2001
Posts: 202
Likes: 1
From: Temecula, CA
Car: '99 Cobra
Engine: 4.6 DOHC 32V
Transmission: T-45
Axle/Gears: 4.10
Oil Pressure gauge messed up

Well, my gauge is reading very high when i start the car (like near 60) and when i get above 2000 rpms, it jumps all the way to the right. somtimes it does it in relation to whether or not i floor it or not, but i dont know what the deal is. do these cars have oil sensors in the traditional sense, and if so, how hard is it to change out?

thanks a lot!
Reply
Old Aug 2, 2002 | 12:37 AM
  #2  
ikilu2's Avatar
Junior Member
 
Joined: Aug 2002
Posts: 3
Likes: 0
From: Queens, N.Y.
Definately sounds like the oil pressure sensor (oil switch). Most likely it's leaking giving you a sporatic reading. How easy it's changed depends on where it's located on your engine. Most 6 cyls it's located by the oil filter and you just screw it out when you change your oil. But for 8cyls it's located probably behind the distributor. It also screws out but it's reaching it where the problem comes in. If you have a 6cyl., no prob. 8cyl., well just take your time IF there is a clearance prob. Good news also is the part is cheap and can be found at any parts store.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
89GTAOz
Tech / General Engine
13
May 16, 2020 09:31 AM
355sbcTPI
Electronics
2
Aug 19, 2015 04:38 PM
bamaboy0323
Tech / General Engine
2
Aug 15, 2015 07:20 AM
ChevyZ71
Interior
2
Aug 13, 2015 07:30 AM




All times are GMT -5. The time now is 07:55 AM.