89 Formula #1 Plug on Distributor
Thread Starter
Junior Member
Joined: Sep 2002
Posts: 2
Likes: 0
From: Maryland
89 Formula #1 Plug on Distributor
My Formula will not start after I replaced the Cap and Rotor. It was suggested that I may have crossed a couple of wires.
I know that the firing order is 1-8-4-3-6-5-7-2 but I am not sure where the #1 spark plug wire should go on the distributor. Could someone please help me with this?
Thanks.
I know that the firing order is 1-8-4-3-6-5-7-2 but I am not sure where the #1 spark plug wire should go on the distributor. Could someone please help me with this? Thanks.
Supreme Member
Joined: Jul 1999
Posts: 1,335
Likes: 2
From: Tucson, AZ, USA
Car: '92 Z28; Dk Teal; Her Pkg
Engine: 305
Transmission: Richmond 6 Spd
Axle/Gears: Moser 9", Detroit Locker, 3.70
Turn the crankshaft until the timing mark is @ zero degrees. The rotor will be pointing @ 1 or 6 on the distributor. From the factory, 1 is usually near the front driver's side of the distributor.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM