Fuse for gauge burnt out
12-04-2002, 12:17 PM
#1
Member
Thread Starter
Join Date: Dec 2001
Posts: 388
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Z28
Engine: 350 TPI
Transmission: 700R4
Fuse for gauge burnt out
Ok my guages/rear defroster stoped working yesterday so I checked the fuse and it was blown so i replaced it then it worked. then to day i started my car and the gauges/ rear defroster don't work so i checked the fuse again and its burnt out again anyreason this keeps happening and how could i fix it ? would putting a #15 fuse in work ?? Oh yeah i haven't done any thing to the car since i put my airfoil in and that was a couple months ago.
Last edited by 91 z28 350; 12-04-2002 at 12:45 PM.
12-04-2002, 05:37 PM
#2
Member
Join Date: Apr 2002
Location: Columbus,Cleveland
Posts: 439
Likes: 0
Received 0 Likes
on
0 Posts
You should never put a higher value fuse in place of a lower one.(Like I have my break lights right now). From my limited electrical knowledge most blown fuses are caused by a short to ground somwehere in the system. As for finding this, tracing the wires and looking for a bare wire is about the only was I know of fixing the problem. Hope this helps
Thread
Thread Starter
Forum
Replies
Last Post
gta892000
Cooling
6
09-16-2015 12:37 AM
