MSD-6A Wiring Harness
Thread Starter
Supreme Member
iTrader: (1)
Joined: Mar 2001
Posts: 4,226
Likes: 6
From: Chesterfield, Indiana
Car: 1991 Z28 Camaro
Engine: 5.7
Transmission: Jasper 700R4 Stage II
Axle/Gears: 3.23 For Now
MSD-6A Wiring Harness
Hello,
I just bought an MSD-6A Ignition Box for my 1991 Z28. Somebody said that wiring harnesses are available for these so you don't have to cut any wires or anything. Does anyone know where I can get one of the harnesses??? I don't want to cut anything or mess any electrical stuff up. Any Info would be appreciated. Thanks!
I just bought an MSD-6A Ignition Box for my 1991 Z28. Somebody said that wiring harnesses are available for these so you don't have to cut any wires or anything. Does anyone know where I can get one of the harnesses??? I don't want to cut anything or mess any electrical stuff up. Any Info would be appreciated. Thanks!
Supreme Member
Joined: May 2002
Posts: 2,119
Likes: 0
From: Central NJ
Car: 86 Iroc-Z28
Engine: FB385
Transmission: 700r4
The one i got it part# 8861. Not too sure if it works yet b/c i have not installed them. I have the 6AL, so i do not know if its going to be different. I got mine from Summit. It says "GM HEI MODULE BYPASS CABLE". good luck
Senior Member
Joined: Jul 1999
Posts: 917
Likes: 1
From: Long Island NY
Car: Z28
Engine: 350 TPI
Transmission: 700R4
I'm going to be using the 8876 harness. I haven't installed it yet. but hooked everything up to make sure I know what I'm doing when I install it. This is what summit says about the harness:
MSD offers these harnesses to simplify the installation of a MSD 6 series box on late model vehicles. The harnesses plug in between the ignition coil and the factory coil connector. Four wires with corresponding colors and matching connectors then connect directly to the MSD 6 wires. These harnesses reduce the installation time, eliminate cut wires and allow you to quickly convert back to the factory ignition if ever desired.
Thread
Thread Starter
Forum
Replies
Last Post
