Question is I would like to convert my 89 camaro to push button starting. Can anyone tell me what is involved in doing this and where I can get the parts needed to get this done? Also, how would you shut the engine off with the push button starter setup.

 

I don't think you can do this because of VATS. Might try a remote starting kit from Sears though.

 

would you mind putting your key in and turning it to on .. then using a button to start it ? cause i can route you that way..

 

VATS not withstanding, you just need a switch to turn on the ignition, then a push button to connect the starter wires. All of the wires are in the harness that goes to the steering column.

 

i would like to do this as well...and no i donnot mind putting the key in as well....how would I go about doing this??? I am mainly wanting to do it as an extra SURPRISE to somone who might try to nab my car....first they will have VATS on their *** and 2nd they wont beable to find the push button to start it...not like a theif would think abotu that anyways, unless they knew the car...

thanks...

 

cut the starter wire. i think its yellow under the dash. then connect the end that doesn't go up to the column to the push button, and the other to a switched 12 volt source. or to a constant if u always want to be able to crank it without the ignition.