?Build your own Sealed Battery relocation Box?
Thread Starter
Senior Member
iTrader: (4)
Joined: Feb 2003
Posts: 713
Likes: 1
From: shawnee, ks
Car: 87 Firebird
Engine: 5.3 76mm
Transmission: Rossler TH400, PTC converter
Axle/Gears: Strange 12bolt, 3.08s
?Build your own Sealed Battery relocation Box?
Would it be safe to build your own battery relocation box that could be seal and the vented?
My idea was to take a plastic tub, just large enough to get the battery in, then cut slits in it so that i could mount it to the spare area, silicone (unless there is something better) the slits to the straps for mounting, then use rubber garments as seals for the vent and battery cables.
An air tight system except for the vent. Would this be safe let alone allowed on the drag strip?
My idea was to take a plastic tub, just large enough to get the battery in, then cut slits in it so that i could mount it to the spare area, silicone (unless there is something better) the slits to the straps for mounting, then use rubber garments as seals for the vent and battery cables.
An air tight system except for the vent. Would this be safe let alone allowed on the drag strip?
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
2
Dec 16, 2024 01:50 PM
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
Jun 13, 2021 01:13 PM
Dialed_In
Firebirds for Sale
2
Aug 20, 2015 01:45 PM
