which wire
Thread Starter
Member
iTrader: (1)
Joined: Jul 2004
Posts: 368
Likes: 0
From: sandusky
Car: 1987 iroc z
Engine: 355 dart platinum 215cc heads
Transmission: <<BLOWN UP TH400>>
Axle/Gears: 10 bolt 4.11's
which wire
which wire do i run to my kill switch to make the whole car shut off when i turn the kill switch off thanks.
Moderator
Joined: Jan 2000
Posts: 19,680
Likes: 316
The copper one.
Actually, there are many ways to disable the vehicle. You can interrupt the injection circuit, but that may not be ideal for the ECM outputs. You can interrupt the ignition power. You can interrupt the fuel pump. You could kill all power, but the radio presets and ECM BLM tables would be wiped out every time you do that.
Actually, there are many ways to disable the vehicle. You can interrupt the injection circuit, but that may not be ideal for the ECM outputs. You can interrupt the ignition power. You can interrupt the fuel pump. You could kill all power, but the radio presets and ECM BLM tables would be wiped out every time you do that.
Thread Starter
Member
iTrader: (1)
Joined: Jul 2004
Posts: 368
Likes: 0
From: sandusky
Car: 1987 iroc z
Engine: 355 dart platinum 215cc heads
Transmission: <<BLOWN UP TH400>>
Axle/Gears: 10 bolt 4.11's
yeah i just figured it out i took the back alt wire and hooked to the positive side of the battery worked fine.
Thread
Thread Starter
Forum
Replies
Last Post
Glowsock
Tech / General Engine
3
Jan 9, 2017 04:06 PM
