ECM wiring harness question
Thread Starter
Member
iTrader: (1)
Joined: Oct 2004
Posts: 235
Likes: 0
From: Near Milwaukee, WI
Car: 1989 GTA
Engine: 383 Fuel Injected
Transmission: Pro-Street 700-R4 by Pro-built
Axle/Gears: Moser 12 bolt w/posi
ECM wiring harness question
There are two clamps that go one the ecm wiring harness. They are for the large diameter section and i believe they bolt on to either the bell houseing or the back of the heads. The car is an 89 GTA, if anyone has any info i would appreciate it.
Thread
Thread Starter
Forum
Replies
Last Post
