removing ecm harness 2 questions ??
Thread Starter
Member
Joined: Feb 2006
Posts: 104
Likes: 0
From: Houston
Car: 86 TA
Engine: 305 carb
Transmission: 700 R4
Axle/Gears: Not Sure
removing ecm harness 2 questions ??
I'm removing the harness for the ecm from the passenger side of my 86 ta and there are only two concerns I have.
1. the yellow and black wires for the temp sensor on the water neck are in this harness. Do I need this sensor??
2. the four wires that go to the transmission are part of this harness. I already have the B&M TCC lock up kit for the converter will that replace the purpose of these four wires??
If I need to keep these six wires how do I get them out of the connector that feeds through the fender well??
I have done many
and have looked through many post could not find exactly what I was looking for. 
1. the yellow and black wires for the temp sensor on the water neck are in this harness. Do I need this sensor??
2. the four wires that go to the transmission are part of this harness. I already have the B&M TCC lock up kit for the converter will that replace the purpose of these four wires??
If I need to keep these six wires how do I get them out of the connector that feeds through the fender well??
I have done many
and have looked through many post could not find exactly what I was looking for. 
Thread
Thread Starter
Forum
Replies
Last Post