How to wire glow gauges?
Thread Starter
Supreme Member
Joined: Apr 2008
Posts: 2,342
Likes: 24
From: Dumfries, VA
Car: 1985 Z28
Engine: 334 Stroker Superram 222/230
Transmission: Full Manual 700R4 / 3k Street Edge
Axle/Gears: 3.90 Eaton, Moser, Richmond & More
How to wire glow gauges?
I just bought a set of glow gauges for my 85 Z28.
http://cgi.ebay.com/ebaymotors/ws/eB...TODAY.m238.lVI
The gauges look quality, unfortunately they gave NO instructions what-so-ever. The only part that confuses me is where in the freakin **** do I splice the input wires to that go to the inverter? I can't imagine that I would need the factory gauge backlight with these installed. Can I remove the bulb for this and connect the input wires to the terminals there?
http://cgi.ebay.com/ebaymotors/ws/eB...TODAY.m238.lVI
The gauges look quality, unfortunately they gave NO instructions what-so-ever. The only part that confuses me is where in the freakin **** do I splice the input wires to that go to the inverter? I can't imagine that I would need the factory gauge backlight with these installed. Can I remove the bulb for this and connect the input wires to the terminals there?
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM
