well i have a 1991 firebird formula. i tried to use my brights a couple nights ago and i had to hold the turn signal switch to keep them on. well on my way home i noticed they were stuck on and i cant click them off? how do i fix that?

also my passanger headlight wouldnt go up all the way. so i found a thing online to were you can spin the headlight gear 180* and use the other side thats good. well when i was trying that it didnt work. so then i was holding my headlight up trying to get the arm back on to the motor. and i snapped the top of the headlight bracket on one side.

i found a guy who can give me a entire headlight assembly for 20$ thats motor, bracket, everything. but its from a 86 model. so can i use the motor and bracket tray and just swap everything else over?

i need to know by sunday b/c thats when im suppose to go buy it.

thanks. if something didnt make since. point it out and ill try to reexplain it.

 

The dimmer problem is the switch - it needs readjusted - it's under the column all the way under above the brake pedal - youll see the rod that actiavates the switch moving - lay the seat back all the way down, get a small flashlight, and crawl in with your head in the floorboard, and your feet on the headrest on your back - it's a PITA, but that's where it's at. Oh - take a 7mm short wrench and socket/rachet with you!

 

As Camaronewbie says, it's likely the adjustment of the dimmer switch. Article with the adjusting procedure here: http://www.austinthirdgen.org/index.php?pid=16

Hope this helps.
Lou

 

well i tilted my wheel all the way down and it clicked and turned them off. so now im not worried about it.

any clue on if a 86 headlight will work on a 91?

 

The bulb? Yes.
The assembly with the motor? No.

Lou

 

can i use the headlight motor?

 

well i got the headlight in and everything fit and worked once.

the lights are turning on and the car is grounded fine. but i have to reset the ground everytime to get the headlight motor to work. i messed with the relay but that didnt seem to work? i cleaned the ground for the motors and everything. but nothing seems to work but reseting the ground.

any help please?