Air/Fuel Gauge, Need Second O2?
Thread Starter
Supreme Member
Joined: Apr 2008
Posts: 2,342
Likes: 24
From: Dumfries, VA
Car: 1985 Z28
Engine: 334 Stroker Superram 222/230
Transmission: Full Manual 700R4 / 3k Street Edge
Axle/Gears: 3.90 Eaton, Moser, Richmond & More
Air/Fuel Gauge, Need Second O2?
Hey guys to wire up an autometer narrowband air/fuel ratio gauge, can the stock narrowband O2 sensor run both the ECM and and the gauge accurately or am I going to have to have the shop weld in another O2 bung?
Also, if I need a second O2 sensor what is the most accurate place in the exhaust stream to place it? In one header only like the stock location or after the Y?
Also, if I need a second O2 sensor what is the most accurate place in the exhaust stream to place it? In one header only like the stock location or after the Y?
Thread
Thread Starter
Forum
Replies
Last Post
