Ok so heres the situation. I had removed the emission control system off my camaro and I had removed all the air tubes except one. This last one was attached to the catalytic convertor. But it was also a point where some wires connected to a ground. I was a dumass and cut those wires with scissors not realizing they were wires. but i regrounded those wires but now my car wont crank at all. I mean the fuel pump turns on when i turn the key to the on position but when i go to crank it i get nothing. Anyone got any ideas?

 

What colors are the wires and where were they located ?

 

There are 4 black wires 2 have white stripes and they are all located on the passanger side right above the y pipe.

 

Check to see if the wire to the starter solenoid is still connected.Might have broken it or knocked it loose while removing tube
Check to see if you have 12V on that wire when key turned to start position

 

well i tried and it doesnt have 12v and were not getting 12v. but the only thing is we were looking through the diagram theres only one or 2 black wires in the starting diagram and i didnt see and that were black with white stripes in the diagram