Trunk Will not close
Thread Starter
Junior Member
Joined: Jan 2010
Posts: 46
Likes: 0
Car: 1991 Firebird
Engine: 305 TBI
Axle/Gears: 2.73s
Trunk Will not close
Ok to start off my trunk never sealed evenly to begin with...
the fuse blows like 1 time a month depending on how i close it
and now i cant close the trunk at all... the fuse was blew but i replaced it and it still wont close... now the latch wont even like seal... if i pull up the trunk can open even when its closed... This is ghetto as hell...what do i do?
the fuse blows like 1 time a month depending on how i close it
and now i cant close the trunk at all... the fuse was blew but i replaced it and it still wont close... now the latch wont even like seal... if i pull up the trunk can open even when its closed... This is ghetto as hell...what do i do?
Supreme Member
Joined: Jan 2006
Posts: 3,341
Likes: 10
From: Mooresville NC
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
Junk In The Trunk
When you try to close it, does the latch ♦click♦?
Do you hear a ♦click♦ when you press the console hatch release?
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Make Noise, Turn Left, Repeat
.
Do you hear a ♦click♦ when you press the console hatch release?
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Make Noise, Turn Left, Repeat
.
Thread Starter
Junior Member
Joined: Jan 2010
Posts: 46
Likes: 0
Car: 1991 Firebird
Engine: 305 TBI
Axle/Gears: 2.73s
Re: Trunk Will not close
it was clicking but then i pulled off that plastic panel to look at the motor/mechanism for it and the plastic guides that let it move up and down just fell apart and now basically its all broken... Where can i replace the entire mechanism?
Senior Member
Joined: Sep 2004
Posts: 502
Likes: 1
From: Leesville, LA
Car: 1989 Camaro RS
Engine: Modified 350 TPI
Transmission: Modified 700 R4
Axle/Gears: Posi 3.42
Re: Trunk Will not close
Go to www.tds.com You'll find guides, parts, etc. for your hatch lid motor.
Supreme Member
Joined: Jan 2006
Posts: 3,341
Likes: 10
From: Mooresville NC
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
A Quick Trip As The Hawk Flies
Where can i replace the entire mechanism?
By swapping the unit, it’ll be a faster pit stop than rebuilding your old one.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Slamming The Wall Is Not The Neatest Way To Remove An Engine
.
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
May 17, 2020 10:44 AM
