Hi everyone. Wife and I just purchased our 1st US car, a 1991 RS. As we are in the Land Down Under it was already converted to RHD, fairly well but has it's little gremlins.

The main problem I have now is I need to remove the US drivers side seat (left power seat) )to get it retrimmed, and the electrics are not working.

I can't get to one of the bolts to remove it. I have pulled the power inlet plug under the seat and have power into the switch block but no movement using the switches on the side.

Can anyone help with what to hotwire to get the seat to move forward on the rails (assuming the motors are not burned out.)

I have not taken the switch right out, but assume that there is a 4-5 pin plug going into it that can be hotwired/bridged to allow the seat to slide forward and back.

Any help on correct pins would be much appreciated.

Best wishes,

Craig & Joanne.