power to a painless harness?
Thread Starter
Joined: Jul 2006
Posts: 67
Likes: 1
Car: 89 GTA
Engine: 94 LT1 with Painless Perf. cam kit
Transmission: 700r4 2100 stall conv. Vette servo
power to a painless harness?
what spot in the fuse box would you guys recommend i use for my painless wiring harness "hot" wire? Directions only say to use a slot that is energized when the key is in the start and run position. Swapping a LT1 into a 89GTA. Should i just use the ECM slot seeing as it shouldnt be controling anything?
Supreme Member
iTrader: (1)
Joined: Mar 2007
Posts: 3,525
Likes: 7
From: Arlington, Tx
Car: 91 Camaro RS
Engine: empty bay (for now)
Transmission: Built T-56
Axle/Gears: 3.42 stock posi disc
Re: power to a painless harness?
the fusebox has spots for single male spade terminals, the ones labeled BATT are 12v constant. the ones labeles IGN are switched 12v. the ones labeled LPS (or lamps or something like that) are 12v whenever the lights are on.
Thread
Thread Starter
Forum
Replies
Last Post
sailtexas186548
Problems / Help / Suggestions / Comments
2
Aug 24, 2015 10:11 PM