Need to ID a wire
Need to ID a wire
89 firebird formula. original engine. 5.7 th350 trans
This taped up bundle was going down the passenger side, under the engine block. Most all wires go to the starter. The white one goes to a sensor on the drivers side.. Oil pressure?
My question is.. what does the black one go to?
I was trying to clean up some wiring.. not sure if I cut it.. I think it was already loose. Any guidence o' wise Firebird gurus?
This taped up bundle was going down the passenger side, under the engine block. Most all wires go to the starter. The white one goes to a sensor on the drivers side.. Oil pressure?
My question is.. what does the black one go to?
I was trying to clean up some wiring.. not sure if I cut it.. I think it was already loose. Any guidence o' wise Firebird gurus?
Supreme Member
iTrader: (2)
Joined: Mar 2002
Posts: 1,029
Likes: 1
From: West Houston, Tx.
Car: 1991 Z28
Engine: 355 TPI
Transmission: 700r4
Axle/Gears: 9 bolt disc / 3:27
Re: Need to ID a wire
if i remember correctly at the moment the white one is a knock sensor wire and the black goes to the fan control temp unit on that side of the block... either that or vice versa
Thread
Thread Starter
Forum
Replies
Last Post
Glowsock
Tech / General Engine
3
Jan 9, 2017 04:06 PM




