Need help installing gauges
#1
Junior Member
Thread Starter
Join Date: Jul 2012
Location: Orlando, FL
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Z28
Engine: Rebuilt carbed 305
Transmission: 5-speed
Need help installing gauges
I have just purchased a '91 z28 that has a Sunpro CP8090 tri-gauge half installed and sitting under the hood. The water temperature gauge is connected but the oil pressure and voltage gauges are not. I believe all I have to do is simply run a wire from the battery to the voltage gauge but I'm not sure what I need to do to install the oil pressure gauge. Do I have to purchase a new sender or can I use the stock one, what else if anything do I need to purchase and how would I connect it? Any help would be much appreciated.
Last edited by Bitchin'Camaro; 07-15-2012 at 09:53 PM.
#2
Supreme Member
iTrader: (35)
Join Date: Aug 2006
Location: Mississauga,Ont,Canada
Posts: 1,470
Likes: 0
Received 1 Like
on
1 Post
Car: 89 IROC
Engine: LSX 6.0 370, TU2 Cam, Fast intake
Transmission: T56 w/ lots of goodies
Axle/Gears: 8.8, Posi, 4.10, 31 Spline
Re: Need help installing gauges
voltage just goes to a 12v switched source. Im not sure if you can hook it to a battery or not but you can try
oil pressure you need the fittings for the line, is it mechanical or electric? if its electric you need a sender. you can attach either to the back of the block or just above the oil filter.
oil pressure you need the fittings for the line, is it mechanical or electric? if its electric you need a sender. you can attach either to the back of the block or just above the oil filter.
Thread
Thread Starter
Forum
Replies
Last Post
86IROC112
Engine/Drivetrain/Suspension Parts for Sale
4
08-17-2015 02:00 PM