Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

car will not start

Thread Tools
 
Search this Thread
 
Old Aug 8, 2012 | 07:13 PM
  #1  
endo666's Avatar
Thread Starter
Member
 
Joined: Aug 2009
Posts: 128
Likes: 0
From: Omaha, NE
Car: 84 Camaro
Engine: 350
Transmission: Stock 5 Speed
Axle/Gears: 3.73
car will not start

My car will not start seams to be an intermittent problem. no cranking of engine.

I have a switch that i have to hold to the on position then turn the key to get the car to start (added by previous owner)

one day the car wouldn't start so i jumped 2 wires that hook into a something on the clutch pedal under the dash. I think it is the safety switch. car fired up.

two weeks ago my car wouldn't start. tried jumping the same wires nothing. put the wires back and replaced the starter car still wouldn't start. removed the 2 wires again and hooked them permanently together and the car fired right up.

car will not start again. I kind of wiggled my foot on the clutch peddal and it started to turn over but about half a second to short to start.

Any suggestion?

i want to try to replace the ignition switch is this easy?
Reply
Old Aug 8, 2012 | 08:33 PM
  #2  
vetteoz's Avatar
Supreme Member
20 Year Member
iTrader: (13)
 
Joined: Apr 2005
Posts: 7,736
Likes: 14
From: Not in Kansas anymore
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: car will not start

Originally Posted by endo666
i want to try to replace the ignition switch is this easy?
https://www.thirdgen.org/forums/post...71-post19.html
Reply
Old Aug 11, 2012 | 10:21 PM
  #3  
waltersb's Avatar
Member
 
Joined: Dec 2001
Posts: 471
Likes: 0
From: Burnaby, BC, Canada
Car: 1989 Camaro Iroc-Z
Engine: 305 TPI (LB9)
Transmission: Auto 4
Re: car will not start

Sounds like there's a short in your 2 wires somewhere...
Reply
Old Aug 12, 2012 | 03:05 PM
  #4  
Ozz1967's Avatar
Supreme Member
20 Year Member
iTrader: (4)
 
Joined: Dec 2005
Posts: 4,795
Likes: 15
From: St. Cloud, MN
Car: 1984 Trans Am
Engine: LS1383 in work
Transmission: Magnum F - to be installed
Axle/Gears: Zexel Torsen 3.73, 28-spline mosers
Re: car will not start

Originally Posted by waltersb
Sounds like there's a short in your 2 wires somewhere...


I dont' know what the two wires are, could be neutral safety, could be ignition. You'll need to pick up a wiring diagram and try and figure it out.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
midge54
LTX and LSX
21
Dec 27, 2019 04:14 PM
Wade787b
TPI
2
Sep 29, 2015 01:15 PM
killer777
Tech / General Engine
0
Aug 8, 2015 02:47 PM
L98GTA87
Tech / General Engine
0
Aug 5, 2015 11:02 PM




All times are GMT -5. The time now is 01:02 AM.