Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

So I tore into my headlight motor today

Thread Tools
 
Search this Thread
 
Old Aug 9, 2012 | 04:27 PM
  #1  
soul.justice's Avatar
Thread Starter
Member
 
Joined: Jul 2012
Posts: 197
Likes: 0
From: Middle TN
Car: 1985 Firebird Trans Am
Engine: 305 4bbl
Transmission: 700R4
Axle/Gears: 3.08
So I tore into my headlight motor today

I'm fairly certain this motor has been repaired before as I wouldn't think these things were weather sealed with acrylic painter's caulk from the factory (though I could be wrong) and the internals look good, grease is still fine, except for this. WTF is it, what does it do, and where can I find a replacement? For clarity I am referring to the square piece on the shaft immediately after the spring that also has a piece pointing up. There were originally two I'm assuming as I found one of them in pieces out of the same motor...

Name:  2012-08-09_16-09-06_77.jpg
Views: 31
Size:  83.3 KB

broken piece out of the same motor
Name:  2012-08-09_16-09-25_234.jpg
Views: 33
Size:  110.0 KB
Reply
Old Aug 9, 2012 | 05:46 PM
  #2  
ImBrandon's Avatar
Member
 
Joined: Apr 2012
Posts: 139
Likes: 0
From: Philadelphia,Pa
Car: 1991 Pontiac Trans Am
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 3:42
Re: So I tore into my headlight motor today

I don't think you can get that hardware from an online store you might have to get a hard part like that from the junkyard and swap it in.
Reply
Old Aug 9, 2012 | 06:02 PM
  #3  
soul.justice's Avatar
Thread Starter
Member
 
Joined: Jul 2012
Posts: 197
Likes: 0
From: Middle TN
Car: 1985 Firebird Trans Am
Engine: 305 4bbl
Transmission: 700R4
Axle/Gears: 3.08
Re: So I tore into my headlight motor today

Originally Posted by ImBrandon
I don't think you can get that hardware from an online store you might have to get a hard part like that from the junkyard and swap it in.
Pretty sure I'm not going to find it online either. And its damn near impossible to find third gen firebirds around here let alone one with the motors still on the car. I'd really hate to buy a new headlight motor just for this one piece as the motor itself is still fine, it just wouldn't move the light (probably because the broken piece was binding the motor up).
Reply
Old Aug 10, 2012 | 08:27 PM
  #4  
ImBrandon's Avatar
Member
 
Joined: Apr 2012
Posts: 139
Likes: 0
From: Philadelphia,Pa
Car: 1991 Pontiac Trans Am
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 3:42
Re: So I tore into my headlight motor today

I'd pull one for you if you pay for shipping and other costs.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
BRoss99
Electronics
28
Aug 10, 2025 05:08 PM
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
spaigo
Transmissions and Drivetrain
4
Aug 21, 2015 07:46 PM
Fronzizzle
Electronics
3
Aug 17, 2015 02:52 PM




All times are GMT -5. The time now is 05:50 AM.