Printed Circuit Board Terminals.
Thread Starter
Member
Joined: Jul 2011
Posts: 174
Likes: 0
From: Billings, MT
Car: 92 Firebird--02 Grand Prix GTP 2Dr
Engine: Poncho 400--3.8 Supercharged
Transmission: T56 6 Speed--4T65EHD
Axle/Gears: Open 10 bolt 3.42--Internal 2.93
Printed Circuit Board Terminals.
Does anyone know where i can find any of the terminals that connect to the printed circuit in the gauge cluster? I'm building a full wiring harness from scratch and everywhere ive looked says theyve discontinued the terminals.
This is what they look like.
This is what they look like. 
Supreme Member
iTrader: (8)
Joined: Aug 2003
Posts: 7,240
Likes: 6
From: LeRoy, NY
Car: 2003 Hyundai Tiburon GT
Engine: 2.7L V6
Transmission: 6-speed
Axle/Gears: 4.41
Re: Printed Circuit Board Terminals.
Would you rather have full harness connectors? I have a pair on a harness I harvested connectors out of for my 4th gen swap.
Joined: Dec 2004
Posts: 16,901
Likes: 1,014
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: Printed Circuit Board Terminals.
http://www.mouser.com/Search/Refine....er%7c0&FS=True
I think this is the size you need
http://www.powerandsignal.com/IDC/DisplayResults2.aspx
I think this is the size you need
http://www.powerandsignal.com/IDC/DisplayResults2.aspx
Last edited by Tuned Performance; Mar 15, 2013 at 03:31 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Linson
Auto Detailing and Appearance
12
Oct 1, 2015 09:50 PM
