Fuel sending unit wiring
Thread Starter
Junior Member
Joined: Mar 2012
Posts: 4
Likes: 0
Fuel sending unit wiring
Hey, everyone. I have a 1991 Camaro RS, and I'm replacing the fuel pump.
Since I dropped the gas tank, I've noticed another problem. The wire that connects to the fuel level sensor came off. I probably pulled it off by accident. The problem is, it was pressed on, and now it won't re-attach. It looked like a spade connector with an extremely close fit that was just pressed on to a little metal nub on the sending unit.
Any ideas on how to re-attach it? I could JB Weld it, but that's my least favorite way to fix it.
Since I dropped the gas tank, I've noticed another problem. The wire that connects to the fuel level sensor came off. I probably pulled it off by accident. The problem is, it was pressed on, and now it won't re-attach. It looked like a spade connector with an extremely close fit that was just pressed on to a little metal nub on the sending unit.
Any ideas on how to re-attach it? I could JB Weld it, but that's my least favorite way to fix it.
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM
92camaroJoe
Tech / General Engine
6
Aug 13, 2015 06:07 AM
