Electronics Need help wiring something up? Thinking of adding an electrical component to your car? Need help troubleshooting that wiring glitch?

engine swap now gas pump wont start

Thread Tools
 
Search this Thread
 
Old Jun 12, 2014 | 06:51 PM
  #1  
camsuper88's Avatar
Thread Starter
Junior Member
 
Joined: Jun 2014
Posts: 22
Likes: 0
From: all over
Car: 88 iroc-z camaro
Engine: 305 tbi
Transmission: 700r4
Axle/Gears: idk
engine swap now gas pump wont start

im new here and need help with my 88 iroc-z. it has 198,000 miles so i opted for an engine and tranny swap. i put in a new block and a tranny from an 89. my friend helped me time it but now the fuel pump wount prime. the new engine dose not have all the emissions stuff anymore. i have tried replacing a bunch of stuff but it still will not get fuel. please help. any ideas are welcome.
Reply
Old Jun 25, 2014 | 05:38 PM
  #2  
NINÅ's Avatar
Supreme Member
 
Joined: Jan 2006
Posts: 3,341
Likes: 10
From: Mooresville NC
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
Not Ready 4 Prime Time

To test the relay and pump simultaneously use a spare piece of wire and jump the orange wire to the green wire with the white stripe.

Did you hear the pump run when you did that?


Happy Racing !



When you see fog or “running” lights on in good weather beware. WLow performance driver ahead.

Reply
Old Jun 25, 2014 | 10:31 PM
  #3  
camsuper88's Avatar
Thread Starter
Junior Member
 
Joined: Jun 2014
Posts: 22
Likes: 0
From: all over
Car: 88 iroc-z camaro
Engine: 305 tbi
Transmission: 700r4
Axle/Gears: idk
Re: engine swap now gas pump wont start

i ran a wire from the battery to the fuel pump port on the computer connection under the steering wheel and the pump kicks on. it just wont prime when i turn the key.
Reply
Old Jun 30, 2014 | 08:37 AM
  #4  
NINÅ's Avatar
Supreme Member
 
Joined: Jan 2006
Posts: 3,341
Likes: 10
From: Mooresville NC
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
Not Ready 4 Prime Time

Originally Posted by camsuper
it just wont prime when i turn the key
With the car OFF, using a voltmeter with long leads so you can see it in the cockpit, probe the green wire with a
White stripe at the pump relay.

Now turn the key to the RUN position.

Did the voltmeter show voltage?

If no, there is a faulty ECM or bad connection going to it.


Happy Racing !



8 Wheels Corner Better Than 4, If You’re On The Outside You Have Fair Warning

Reply
Old Jul 6, 2014 | 04:31 PM
  #5  
camsuper88's Avatar
Thread Starter
Junior Member
 
Joined: Jun 2014
Posts: 22
Likes: 0
From: all over
Car: 88 iroc-z camaro
Engine: 305 tbi
Transmission: 700r4
Axle/Gears: idk
Re: engine swap now gas pump wont start

so i figured out what is wrong with my car totally by accedent. i bought a new computer for it but put the old one back in and it fired right up. so i guess i just reset it.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Frozer!!!
Camaros for Sale
35
Jan 19, 2024 04:55 PM
theshackle
Tech / General Engine
4
Mar 5, 2017 06:37 PM
Spyder_TheGamer
Tech / General Engine
1
Dec 25, 2015 05:07 PM
Jae992
TBI
3
Aug 27, 2015 09:07 AM
bradleydeanuhl
DFI and ECM
4
Aug 12, 2015 11:48 AM




All times are GMT -5. The time now is 03:19 AM.