Constant power to A/C idle solenoid
Thread Starter
Member
Joined: Aug 2015
Posts: 126
Likes: 0
From: Key West, FL
Car: 1984 Z28
Engine: LG4 305/4bbl for now
Transmission: 5-Speed
Axle/Gears: 3.23 Posi
Constant power to A/C idle solenoid
So on my 84 Z28 LG4 with the computer removed and an edelbrock 600 installed in it, the wire going to my A/C idle solenoid is getting a constant 12V when the key is on whether the A/C is on or off. I was wondering if anyone had any ideas on where to start troubleshooting? I am stumped.
Supreme Member
Joined: Jan 2006
Posts: 3,341
Likes: 10
From: Mooresville NC
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
Just The Cold Facts
Your car is modified therefore your best bet is to disconnect and protect from shorting to ground, the hot-side wire to the idle solenoid, then run a new wire from the solenoid to the hot-side of the A/C compressor.
Now the solenoid will only be activated when you want A/C.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing !
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
After The Fourth Barrel Roll I Lost Control Of The Car
Now the solenoid will only be activated when you want A/C.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing !
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
After The Fourth Barrel Roll I Lost Control Of The Car
Thread
Thread Starter
Forum
Replies
Last Post
Dracula
Carburetors
26
Sep 24, 2016 08:00 AM